Company Name

OIL CONCENTRATE

Motor oil is the life-blood of an engine. Also, it serves as a medium to dissipate heat. Since lubrication is such an important factor in keeping the vehicle on the road it just makes good sense to obtain the best lubrication possible.
The categories of motor oil are “natural and synthetic”. Natural oil is refined from crude oil which is pumped from the ground. Synthetic oil uses a base of petroleum hydrocarbon material combined with “esters” – which are derivatives of various other products. These are then blended to make the synthetic lubricant. All motor oils are then enhanced with additional ingredients to give them increased flow, anti-foaming and non-corrosive characteristics, as well as viscosity indexes, which enable the oils to flow properly under varying environmental and demand related circumstances. All oils are marketed under the premise that they will provide a measure of protection against metal fatigue and engine wear. However, it has been proven that engines still wear out and experience dry starts when your engine has been stopped long enough for the oil to drain back into the pan – even when employing the highest grade synthetic products.

The technology to enhance any oil exists today — Dyna–Lube Oil Additive — which can not only eliminate the dry starts that reduce the life of your equipment but has been proven to extend the service life by 2-3 times when added to any lubricant. Dyna-Lube Oil Additive is the result of over 50 years of hands on experience and research that led to the discovery/creation of a new “balanced” lubricant molecule. This additive reduces friction to a fraction, speeds up flow and actually impregnates the micro-pores of the metal leading to increased horse power, better fuel economy and a reduction in energy needed to operate equipment. The elimination of the dry start also reduces the drain on your battery which is especially noticeable in cold weather.

Other applications (other than engines/motors) include:
  • Transmissions (Standard and Automatic)
  • Gear Boxes
  • Power Steering Pumps
  • Hydraulic Components
  • Turbines
  • Two Cycle Engines
  • Water Pumps
  • Generators

Recommended use for Dyna – Lube Oil Additives

  • For engines (except two-cycle) - Use two ounces of oil additive per quart of engine oil.
  • For two-cycle engines - Add two ounces of additive per quart of two-cycle pre-mixed oil. Then utilize according to the ratio recommended for your equipment.
  • For gear boxes, standard transmissions and differentials - Use two ounces of additive per quart of base oil.
  • For automatic transmissions, power steering and hydraulic components - Use one ounce per quart of base oil.

Dyna-Lube's Oil concentrate has had four significant independent laboratory test performed. These test were conducted by Auto Research Laboratories Incorporated.

Test #1: FOUR-BALL WEAR COEFFICIENT OF FRICTION TEST ASTM-D4172

Test #2: COPPER STRIP CORROSION ASTM-D130

Test #3: HIGH FOAMING CHARACTERSITICS ASTM-D4739

Test #4: TOTAL BASE NUMBER, mgKOH/g ASTM-D4739